With a quick drive by car, just get into the windshield with one stone, and you are provided with a web with a web. Want to replace the glass? What do you buy new and call the assistant. But before you need to get rid of broken glass. It is most convenient to squeeze it out with your feet, settling in the front seat and resting at the two upper corners of the glass. In this case, it is necessary that the assistant holds the glass outside, so that it does not damage the hood.
With a quick drive by car, just get into the windshield with one stone, and you are provided with a web with a web. Want to replace the glass? What do you buy new and call the assistant. But before you need to get rid of broken glass. It is most convenient to squeeze it out with your feet, settling in the front seat and resting at the two upper corners of the glass. In this case, it is necessary that the assistant holds the glass outside, so that it does not damage the hood.
Having removed the glass, remove the insulation from it. Free the opening of the glass from the fragments, if any, and the old mastic. Do the same with a rubber seal. Put on a new glass seal and enter a metallized plastic edging into its profile. It is installed in a rubber seal so that its joint is located in the center below the glass. Now, using a screwdriver, lay a nylon cord or a flexible electrical wiring with a diameter of 4-5 mm in a fabric stocking in the outer groove of the sealing. Often in car dealerships where the car was purchased when replacing glass and components make a gift to the motorist or give a good discount.
Further, naturally you need to insert this glass into the window opening of the body so that the ends of the cord are inside the body. Holding one of the ends, pull the second end of the cord and remove the lower edge of the rubber seal inside the cabin for the protruding flange of the window opening. Get over the opposite end of the cord and pull it around the entire perimeter of the glass, dragging the edge of the seal into the salon. Having put the glass in place, now we tightly press the special and high -quality seal along the entire perimeter, tapping the hand of the hand along the perimeter of the window with the palm of the hand. Only now you can fix the junction of the edges with a facing bracket, tucking its ends into the groove of the seal. As you can see, there is nothing complicated, it is only necessary to comply with all these rules.
